Carrier 58D 58U 9SM Gas Furnace Owners Manual

58DXT, 58UXT WeatherMaker® 8000 Two-Stage Induced-Combustion Gas Furnaces Visit www.carrier.com Service and Maintenance Instructions For Sizes 060-120, Series 130 NOTE: Read the entire instruction manual before starting the installation. This symbol indicates a change since the last issue. TABLE OF CONTENTS SAFETY CONSIDERATIONS .1 INTRODUCTION 2 ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS PROCEDURE 2 CARE AND MAINTENANCE .2 Cleaning and/or Replacing Air Filter .2 Blower Motor and Wheel .3 Cleaning Heat Exchanger .5 Electrical Controls and Wiring .6 WIRING DIAGRAMS .7 TROUBLESHOOTING .7 EFFICIENCY RATING CERTIFIED A94086 Fig.

2–Model 58DXT Downflow rr ier Cor pora ti on Ca CERTIFIED SO 900 E R E D F8 3 1 #A28 REGISTERED QUALITY SYSTEM IR Fig. 1–Model 58UXT Horizontal SAFETY CONSIDERATIONS Installing and servicing heating equipment can be hazardous due to gas and electrical components. Only trained and qualified personnel should install, repair, or service heating equipment. Untrained personnel can perform basic maintenance functions such as cleaning and replacing air filters. All other operations must Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Book 1 4 PC 101 Catalog No. 535-80047 Printed in U.S.A. Form 58D,U-9SM Pg 1 11-01 Replaces: 58D,U-8SM Tab 6a 8a REG I ST ® M I A95137 A94085 Fig. 3–Model 58UXT Upflow be performed by trained service personnel. When working on heating equipment, observe precautions in the literature, tags, and labels attached to or shipped with the unit and other safety precautions that may apply. Follow all safety codes. In the United States, follow all safety codes including the National Fuel Gas Code (NFGC) NFPA No. 54-1999/ANSI Z223.1-1999. In Canada, refer to the current edition of the National Standard of Canada CAN/CGA-B149.1and .2-M00 Natural Gas and Propane Gas Installation Codes (NSCNGPIC) and Amendment No. 1. Wear safety glasses and work gloves. Have fire extinguisher available during start-up and adjustment procedures and service calls. Recognize safety information. This is the safety-alert symbol. When you see this symbol on the furnace and in instructions or manuals, be alert to the potential for personal injury. Understand the signal words DANGER, WARNING, CAUTION, and NOTE. These words are used with the safety-alert symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING signifies hazards which could result in personal injury or death. CAUTION is used to identify unsafe practices which would result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in enhanced installation, reliability, or operation. or yourself into contact with the furnace. Put all used AND new controls into containers before touching ungrounded objects.