Carrier 58T 2SI Gas Furnace Owners Manual

QUIK·VENTTM Tables For 1- and 2-Stage Category I Fan-Assisted Furnaces Installation Instructions NOTE: Read the entire instruction manual before starting the installation. SAFETY CONSIDERATIONS Installing and servicing heating equipment can be hazardous due to gas and electrical components. Improper installation, adjustment, alterations, service, maintenance, or use can cause explosion, fire, electrical shock, asphyxiation, or other conditions which may cause personal injury, death, or property damage.

Heating, Ventilating and Air Conditioning User Manual Free Download. HAVC Operator’s Manual. Gas Furnace and AC Free Instruction Manual Download PDF.

Only trained and qualified personnel should install, repair, or service heating equipment. Wear safety glasses, protective clothing, and work gloves. Have a fire extinguisher available during start-up and adjustment procedures and service calls. Read these instructions thoroughly. Follow all warnings or cautions included in literature and attached to equipment. Follow all safety codes including local building codes, the National Fuel Gas Code (NFGC) ANSI Z223.1-1992/NFPA 54-1992 in the United States and the National Standard of Canada for Natural Gas and Propane Installation Codes (NSCNGPIC) CAN/CGA-B149.1 and .2-M91 and Amendment No. 1 in Canada. Recognize safety information. This is the safety-alert symbol. When you see this symbol on the furnace and in instructions or manuals, be alert to the potential for personal injury. Understand the signal words DANGER, WARNING, and CAUTION. These words are used with the safety-alert symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING signifies a hazard which could result in personal injury or death. CAUTION is used to identify unsafe practices which would result in minor personal injury or product and property damage. INTRODUCTION Category I furnaces operate with a nonpositive vent static pressure to limit the potential for vent gas leakage, and operate with a flue loss not less than 17 percent to limit the potential for condensation in the venting system. This information supplements the information found in the Installation, Start-Up, and Operating Instructions provided with this furnace. All venting instructions for 1-stage and 2-stage, Category I fan-assisted or induced-draft appliances are included in these instructions. Refer to the QUIK·VENTTM Table Application Chart located on page 4 to determine the appropriate table to use for the furnace type and vent type. References made in this publication to the NFGC NFPA 541992/ANSI Z223.1-1992 apply to installations in the United States of America. References made to the NSCNGPIC CAN/CGAB149.1-M91 and .2-M91 and Amendment No. 1 apply to installations in Canada. Venting systems for Carrier fan-assisted furnaces shall be made in accordance with 1 of the above codes and all authorities having jurisdiction. GENERAL INSTRUCTIONS These instructions are for fan-assisted furnaces classified as Category I furnaces in accordance with ANSI Z21.47b-1992. Type-B connector and vent pipe, single-wall metal connector pipe, and/or lined masonry chimneys shall be used to vent Category I furnaces in accordance with these venting instructions. Chimneys shall conform to ANSI/NFPA 211-1992 in the United States and to a Provincial or Territorial Building Code in Canada (in its absence, the National Building Code of Canada). A clay tile chimney liner in poor condition can be relined in lieu of repairing or rebuilding if the rest of the chimney is in good condition. If the rest of the chimney is in poor condition, repairing or rebuilding is required. UL listed (ULC listed in Canada) metal liner or a UL listed Type-B vent pipe shall be used for relining.

Wikipedia’s page for Carrier

Carrier Company Web Site: www.corp.carrier.com