MTD Troy-Bilt LS338 Log Splitter Lawn Mower Owners Manual

Operator’s Manual Log Splitter Model LS338 IMPORTANT: Read safety rules and instructions carefully before operating equipment. Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forestcovered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

Lawn Mower User Manual Free Download. Walk Behind Mowers Operator’s Manual. Power Mower Free Instruction Manual Download PDF.

In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 361131 Cleveland, Ohio 44136-0019. TROY-BILT LLC. P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 PRINTED IN U.S.A. FORM NO. 769-00089.fm (3/2002) TABLE OF CONTENTS Content Page Important Safe Operation Practices . 3 Assembling Your Log Splitter 5 Know Your Log Splitter 9 Operating Your Log Splitter . 10 Adjusting Your Log Splitter 12 Maintaining Your Log Splitter . 12 Storing Your Log Splitter 14 Troubleshooting . 14 Parts List 16 FINDING MODEL NUMBER This Operator’s Manual is an important part of your new log splitter. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Before you start assembling your new equipment, please locate the model plate on the equipment and copy the information from it in the space provided below. The information on the model plate is very important if you need help from our Customer Support Department or an authorized dealer. · You can locate the model number by standing behind the unit and looking down at the hydraulic tank. A sample model plate is explained below. For future reference, please copy the model number and the serial number of the equipment in the space below. Copy the model number here: www.troybilt.com TROY-BILT LLC P. O. BOX 3 6 1 1 3 1 CLEVELAND, OH 44136 330-558-7220 866-840-6483 Copy the serial number here: ENGINE INFORMATION The engine manufacturer is responsible for all engine-related issues with regards to performance, powerrating, specifications, warranty and service. Please refer to the engine manufacturer’s Owner’s/Operator’s Manual packed separately with your unit for more information. CALLING CUSTOMER SUPPORT If you have difficulty assembling this product or have any questions regarding the controls, operation or maintenance of this unit, please call 1-866-840-6483 or 1-330-558-7220 to reach a Customer Support representative. Please have your unit’s model number and serial number ready when you call. See previous section to locate this information. You will be asked to enter the serial number in order to process your call. For more details about your unit, visit our website at www.troybilt.com 2 SECTION 1: IMPORTANT SAFE OPERATION PRACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. When you see this symbol – heed its warning. WARNING: Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. General Practices 1. Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts. Be familiar with all controls and proper operation. Know how to stop the machine and disengage them quickly. Never allow children under 16 years to operate this machine. Children,16 years and over, should read and understand instructions and safety rules in this manual and should be trained and supervised by a parent. Never allow adults to operate this machine without proper instruction. Many accidents occur when more than one person operates the machine. If a helper is assisting in loading logs, never activate the control until the helper is a minimum of 10 feet from the machine. Keep bystanders, helpers, pets, and children at least 20 feet from the machine while it is in operation. Never allow anyone to ride on this machine. Never transport cargo on this machine. Hydraulic log splitters develop high fluid pressures during operation. Fluid escaping through a pin hole opening can penetrate your skin and cause blood poisoning, gangrene, or death. Give attention to the following instructions at all times: a. Do not check for leaks with your hand. b. Do not operate machine with frayed, kinked, cracked, or damaged hoses, fitting, or tubing. c. Stop the engine and relieve hydraulic system pressure before changing or adjusting fittings, hoses, tubing, or other system components. d. Do not adjust the pressure settings of the pump or valve. Leaks can be detected by passing cardboard or wood, while wearing protective gloves and safety glasses, over the suspected area. Look for discoloration of cardboard or wood. If injured by escaping fluid, see a doctor immediately. Serious infection or reaction can develop if proper medical treatment is not administered immediately. Keep the operator zone and adjacent area clear for safe, secure footing. 3 8. If your machine is equipped with an internal combustion engine and it is intended for use near any unimproved forest, brush, or grass covered land, the engine exhaust should be equipped with a spark arrester. Make sure you comply with applicable local, state, and federal codes. Take appropriate firefighting equipment with you. 9. This machine should be used for splitting wood only, do not use it for any other purpose. 10. Follow the instructions in the manual(s) provided with any attachment(s) for this machine. 2. 3. 4. 5. Preparation 1. 2. 3. 4. 5. 6. 7. 8. 9. Always wear safety shoes or heavy boots. Always wear safety glasses or safety goggles during operating this machine. Never wear jewelry or loose clothing that might become entangled in moving or rotating parts of the machine. Make sure machine is on level surface before operating. Always block machine to prevent unintended movement, and lock in either horizontal or vertical position. Always operate this machine from the operator zone(s) specified in the manual. Logs should be cut with square ends prior to splitting. Use log splitter in daylight or under good artificial light. To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes which can ignite. Wash your skin and change immediately. a. Use only an approved gasoline container. b. Extinguish all cigarettes, cigars, pipes, and other sources of ignition. c. Never fuel machine indoors. d. Never remove gas cap or add fuel while the engine is hot or running. e. Allow engine to cool at least two minutes before refueling. f. Never overfill the fuel tank. Fill tank to no more than 1/2 inch below bottom of filler neck to provide space for fuel expansion. g. Replace gasoline cap and tighten securely. h. If gasoline is spilled, wipe it off the engine and 6. 7. 8. 9. 5. 6. 7. i. j. equipment. move machine to another area. Wait 5 minutes before starting the engine. Never store the machine or fuel container inside where there is an open flame, spark or pilot light as on a water heater, space heater, furnace, clothes dryer or other gas appliances. Allow machine to cool 5 minutes before storing. Maintenance and Storage 1. Stop the engine, disconnect the spark plug and ground it against the engine before cleaning, or inspecting the machine. Stop the engine and relieve hydraulic system pressure before repairing or adjusting fittings, hoses, tubing, or other system components. To prevent fires, clean debris and chaff from the engine and muffler areas. If the engine is equipped with a spark arrester muffler, clean and inspect it regularly according to manufacturers instructions. Replace if damaged. Periodically check that all nuts and bolts, hose clamps, and hydraulic fittings are tight to be sure equipment is in safe working condition. Check all safety guards and shields to be sure they are in the proper position. Never operate with safety guards, shields, or other protective features removed. The pressure relief valve is preset at the factory. Do not adjust the valve. Never attempt to move this machine over hilly or uneven terrain without a tow vehicle or adequate help. For your safety, replace all damaged or worn parts immediately with original equipment manufacturer’s (O.E.M.) parts only. “Use of parts which do not meet the original equipment specifications may lead to improper performance and compromise safety! ” Do not alter this machine in any manner, alterations such as attaching a rope or extension to the control lever, or adding to the width or height of the wedge may result in personal injury. 2. Operation 1. Before starting this machine, review the “Safety Instructions “. Failure to follow these rules may result in serious injury to the operator or bystanders. Never leave this machine unattended with the engine running. Do not operate machine while under the influence of alcohol, drugs, or medication. Never allow anyone to operate this machine without proper instruction. Always operate this machine with all safety equipment in place and working. Make sure all controls are properly adjusted for safe operation. Do not change the engine governor settings or overspeed the engine. The governor controls the maximum safe operating speed of the engine. When loading a log, always place your hands on the sides of the log, not on the ends, and never use your foot to help stabilize a log. Failure to do so, may result in crushed or amputated fingers, toes, hand, or foot. Use only your hand to operate the controls. Never attempt to split more than one log at a time unless the ram has fully extended and a second log is needed to complete the separation of the first log. For logs which are not cut square, the least square end and the longest portion of the log should be placed toward the beam and wedge, and the square end placed toward the end plate. When splitting in the vertical position, stabilize the log before moving the control. Split as follows: a. Place log on the end plate and turn until it leans against the beam and is stable. b. When splitting extra large or uneven logs, the log must be stabilized with wooden shims or split wood between the log and end plate or ground. Always keep fingers away from any cracks that open in the log while splitting. They can quickly close and pinch or amputate your fingers. Keep your work area clean. Immediately remove split wood around the machine so you do not stumble over it. Never move this machine while the engine is running. This machine should not be towed on any street, highway or public road without checking the existing federal, state, or local vehicle requirements. Any licensing or modifications such as taillights, etc., needed to comply, is the sole responsibility of the purchaser. If a “Statement of Origin ” is required in your state, see your local dealer. Do not tow machine faster than 45mph. See Transporting the Log Splitter section in this manual for proper towing instructions once all federal, local, or state requirements are met. 3. 2. 3. 4. 5. 4. 5. 6. 7. 8. 6. 7. 9. 8. 9. Your Responsibility Restrict the use of this power machine to persons who read, understand and follow the warnings and instructions in this manual and on the machine. Some of the safety labels are reproduced here. Always follow directions on safety labels found on your equipment. 10. 11. 12. 13. 14. 15. 16. 17. 4 SECTION 2: ASSEMBLING YOUR LOG SPLITTER Unpacking from Crate · Pry top, sides, and ends off the crate. Set panels aside to avoid tire puncture or personal injury. Remove and discard plastic bag that covers unit. Remove any loose parts if included with unit (i.e., operator’s manual, etc.) Cut and remove straps which secure parts to bottom of crate. Unbolt any remaining parts which may be bolted to the bottom of the crate. Before Assembling · Disconnect spark plug wire and ground against the engine to prevent unintended starting of the log splitter. To locate the spark plug, please refer to the engine manual, shipped seperately with the unit. Attaching Beam Support/Latch Bracket The beam support is already attached to the tongue before shipping. If not, follow instructions below: · · Remove two hex bolts, lock washers, and hex nuts from the tongue. See Figure 2. Place the beam support/latch bracket on the tongue and secure with the hardware just removed. Tighten securely. Hex Bolts WARNING: Use extreme caution while unpacking this machine. Some components are very heavy and will require extra people or mechanical handling equipment to move. Loose Parts 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. R …..

by someone other than an authorized service dealer is not covered by this warranty. Transportation charges and service calls are not covered. No implied warranty, including any implied warranty of merchantability of fitness for a particular purpose, applies after the applicable period of express written warranty above as to the parts as identified. No other express warranty, whether written or oral, except as mentioned above, given by any person or entity, including a dealer or retailer, with respect to any product, shall bind Troy-Bilt LLC. During the period of the warranty, the exclusive remedy is repair or replacement of the product as set forth above. The provisions as set forth in this warranty provide the sole and exclusive remedy arising from the sale. TroyBilt LLC shall not be liable for incidental or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for rental expenses to temporarily replace a warranted product. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above exclusions or limitations may not apply to you. In no event shall recovery of any kind be greater than the amount of the purchase price of the product sold. Alteration of safety features of the product shall void this warranty. You assume the risk and liability for loss, damage, or injury to you and your property and/or to others and their property arising out of the misuse or inability to use the product. This limited warranty shall not extend to anyone other than the original purchaser or to the person for whom it was purchased as a gift. HOW STATE LAW RELATES TO THIS WARRANTY: This limited warranty gives you specific legal rights, and you may also have other rights which vary from state to state. b. c. Troy-Bilt LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019; Phone: 1-866-840-6483, 1-330-558-7220 …

Wikipedia’s page for MTD Products

Company Web Site: www.mtdproducts.com