Carrier Owners Manual - 1 of 2
Carrier Owners Manual - 2 of 2
From inside (document excerpt):
PSC Inducer Motor Housing Assembly Kit Cancels: IIK 340M-40-52 IIK 340M-40-64 3-99 Installation Instructions Part No. 320725-753 NOTE: Read the entire instruction manual before starting the installation. This symbol indicates a change since the last issue. SAFETY CONSIDERATIONS Installing and servicing of heating equipment can be hazardous due to gas and electrical components. Only trained personnel should install or service heating equipment.
Untrained personnel can perform basic maintenance functions such as cleaning coils or cleaning and replacing filters. All other operations should be performed by trained service personnel. When working on heating equipment, observe precautions in the literature, on tags, and on labels attached to the unit. Follow all safety codes. Wear safety glasses and work gloves. Have fire extinguisher available. Recognize safety information. This is the safety-alert symbol. When you see this symbol on the furnace and in instructions or manuals, be alert to the potential for personal injury. MODEL NUMBER 340MAV 350MAV 490AAV 340MAV 350MAV 490AAV 345MAV 351DAS 58MCA 58MXA 58MCA 58MXA 58MSA PG9MAA Table 1–Kit Usage SERIES A, B, C D, E D A, B A 100, 110, 120 130, 140 130 100, 110 A, B USED ON All Sizes All Sizes Except 060120 and 060140* All Sizes Except 060120* All Sizes All Sizes All Sizes Except 120-20 and 140-20* All Sizes Except 120-20* All Sizes Except 060120 and 060140* Understand the signal words DANGER, WARNING, and CAUTION. These words are used with the safety-alert symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING signifies a hazard which could result in personal injury or death. CAUTION is used to identify unsafe practices which would result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in enhanced installation, reliability, or operation. * For 060120 and 120-20 size units on models and series specified, use high output PSC inducer motor housing assembly kit, Part No. 320725-754. For 060140 and 140-20 size units on models and series specified, use high output PSC inducer motor housing assembly kit, Part No. 320725-755. NOTE: Inducer assembly consists of motor and fan, capacitor, wheel, motor mount, inducer cover, inducer housing, vent cap, and vent clamp. INSTALLATION Step 1–Remove Old Motor Assembly 1. Turn off gas and electrical supplies to unit. Before beginning any installation or modification, be sure the main electrical disconnect switch is in the OFF position. Electrical shock can cause personal injury or death. 2. Remove main furnace door. 3. Remove drain tube from inducer motor mounting cover plate. 4. Remove pressure switch tubes. (See Fig. 1.) a. Remove tube attached to pressure switch from collector box. Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. b. Remove tube attached to pressure switch from burner enclosure and gas valve. 5. Remove screw securing pressure switch and capacitor to inducer housing. This instruction covers installation of the permanent split capacitor (PSC) inducer motor kit Part No. 320725-753 on models 340MAV, 345MAV, 350MAV, 351DAS, 490AAV, 58MCA, 58MSA, 58MXA, and PG9MAA Condensing Gas Furnaces.