Carrier 58PA 15SI Gas Furnace Owners Manual

58PAV Upflow Induced-Combustion Furnaces Visit www.carrier.com Installation, Start-Up, and Operating Instructions Sizes 045-155, Series 160 (LIMITED) NOTE: Read the entire instruction manual before starting the installation. Index Page SAFETY CONSIDERATIONS .1 ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS PROCEDURE .3 Dimensional Drawing 2 Clearances From Combustible Materials .3 INTRODUCTION .3-4 LOCATION 4 General 4 Location Relative to Cooling Equipment 4 Hazardous Locations .4 AIR FOR COMBUSTION AND VENTILATION 5 Unconfined Space .5 Confined Space .5 AIR DUCTS 5-6 General Requirements .5-6 Ductwork Acoustical Treatment .6 Supply-Air Connections 6 Return-Air Connections 7 FILTER ARRANGEMENT .7 LEVELING LEGS (IF REQUIRED) 7 GAS PIPING 8 ELECTRICAL CONNECTIONS .8-9 115-v Wiring .8 24-v Wiring .9 Accessories 9 VENTING 10 START-UP, ADJUSTMENT, AND SAFETY CHECK .10-17 General 10 Sequence Of Operation .10 Heating Mode 12 Cooling Mode .12 Continuous Blower Mode .12 Heat Pump Mode 12 Start-Up Procedures .12-17 Adjustments .13 Set Gas Input Rate 13 Set Temperature Rise 13-16 Set Thermostat Heat Anticipator 17 Check Safety Controls 17 Checklist 18 SAFETY CONSIDERATIONS Installing and servicing heating equipment can be hazardous due to gas and electrical components.

Only trained and qualified personnel should install, repair, or service heating equipment. ama CERTIFIED REGISTERED QUALITY SYSTEM Untrained personnel can perform basic maintenance functions such as cleaning and replacing air filters. All other operations must be performed by trained service personnel. When working on heating equipment, observe precautions in the literature, on tags, and on labels attached to or shipped with the unit and other safety precautions that may apply. In the United States, follow all safety codes including the National Fuel Gas Code (NFGC) NFPA 54-1999/ANSI Z223.1-1999 and the Installation Standards, Warm Air Heating and Air Conditioning Systems (NFPA 90B) ANSI/NFPA 90B. In Canada, refer to the CAN/CGA-B149.1- and .2-M95 National Standard of Canada, Natural Gas and Propane Installation Codes (NSCNGPIC). Wear safety glasses and work gloves. Have fire extinguisher available during start-up and adjustment procedures and service calls. Recognize safety information. This is the safety-alert symbol. When you see this symbol on the furnace and in instructions or manuals, be alert to the potential for personal injury. Understand the signal words DANGER, WARNING, CAUTION, and NOTE. These words are used with the safety-alert symbol. DANGER identifies the most serious hazards which will result in severe personal injury or death. WARNING signifies a hazard which could result in personal injury or death. CAUTION is used to identify unsafe practices which would result in minor personal injury or product and property damage. NOTE is used to highlight suggestions which will result in enhanced installation, reliability, or operation. These instructions cover minimum requirements and conform to existing national standards and safety codes. In some instances, these instructions exceed certain local codes and ordinances, especially those that may not have kept up with changing residential construction practices. We require these instructions as a minimum for a safe installation. Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Book 1 4 PC 101 Catalog No. 535-756 Printed in U.S.A. Form 58PA-15SI Pg 1 1-00 Replaces